Tab และ Slot ใน SOLIDWORKS - Metrosystems-DES

To create a tab and slot: In the graphics area, select an edge for the tabs and a corresponding face for the slots The faces can be planar or cylindrical,

However, the typical way to create tabs and slots is to draw a sketch to extrude a tab on one piece of paper Then, you need to convert the

slot demo rp Currently I wait till the design is finished and then add the tab a slot, usually manually, instead of skeletal design this is very time

slot tournaments las vegas Projecting tab or slot geometry to the parts? Wouldn't that Post to forums · Technology Administrators · Autodesk Design & Make Report