Cutting the fret slots -

Cutting the fret slots - fret slot depth It shows you if the fret slot will accept the fret wire that you're about to use What you do is put the fret tang up to these two mark lines The lower line is fret slot width Removable clear acrylic depth stop to precisely set any fret slot depth Our most efficient saw for fret slots! Handmade, each saw cuts on the pull-stroke

fret slot width I found this in about 11 seconds using Google mm - mm = mm minimum slot depth

fret slot depth Later sanding? With frets installed? no- I slot, then glue the FB on, then sand level etc, then fret  Thanks for the reply Fret slot depth should conform to the curve of the top of fretboard, remaining a constant depth approx 3mm Top